Zhanxu Electromechanical - a professional connector equipment manufacturer
News
News Center
Automatic terminal machine use matters needing attention
Release time:
2024-01-19
As an important equipment for wire harness processing, automatic terminal machine has many functions such as feeding, cutting, stripping and pressing. The terminals produced can be connected more conveniently without traditional welding, which effectively promotes the progress of the whole electronic industry and is favored by enterprises. However, once a failure occurs, it will affect the production schedule and the service life of the machine.
As an important equipment for wire harness processing, automatic terminal machine has many functions such as feeding, cutting, stripping and pressing. The terminals produced can be connected more conveniently without traditional welding, which effectively promotes the progress of the whole electronic industry and is favored by enterprises. However, once a failure occurs, it will affect the production schedule and the service life of the machine. Therefore, it is essential to strictly abide by the precautions for the use of the full-automatic terminal machine and the maintenance of the full-automatic terminal machine equipment. Doing a good job in the maintenance of the full-automatic terminal machine can avoid a series of unnecessary problems and ensure the production schedule. And efficiency.
Note:
■ Mold clamping must be accurate and firm; mold clearance is reasonable, often keep the mold edge sharp.
■ It is forbidden to overload the machine, and the punching pressure of the processed workpiece shall not exceed the limited range.
■ Before starting the motor, the clutch must be disengaged and the flywheel in the idling position.
■ When the machine is repaired and maintained by two or more personnel, it is necessary to confirm the safety before starting the operation.
■ During the operation, if the machine has abnormal noise or abnormal reaction, turn off the power supply first, and ask professionals to carry out maintenance and debugging in time.
During the operation, before the power supply of the machine is disconnected, it is forbidden to enter the stamping range of fingers or any part of the body to avoid industrial accidents.
■ During the operation, if you need to leave I for a long time, you must ensure that the power supply is turned off before leaving.
■ When replacing the terminal, you must disconnect the power supply before replacing it. It is strictly forbidden to replace it during the operation of the machine.
■ During the operation, if there is a terminal stuck in the knife die, the machine must be turned off first, and then the operation can be continued only after being cleared by scissors or needle picking.
■ It is strictly prohibited for non-designated staff to debug or disassemble machine parts without permission, so as to avoid potential safety hazards and unnecessary losses.
Latest News
Quality of service to win customer satisfaction
Mobile website
Get Services
Changzhou Zhanxu Electromechanical Co., Ltd.
Mobile: 86-13915833441
E-mail: 13915833441@163.com
QQ：1072144140 / 458686221
Address: Zhonglou Zhihui Industrial Park (Xinlin Road West) -08A, Liandong U-Valley, Zhonglou District, Changzhou City, Jiangsu Province